What Is Ohm's Law & What Does It Tell Us?

George Ohm published the formula for Ohm’s Law in 1827.
••• Ablestock.com/AbleStock.com/Getty Images

Ohm’s Law states that the electric current that passes through a conductor is in direct proportion with the potential difference across it. In other words, the constant proportionality results in the resistance of the conductor. Ohm’s Law states that the direct current that flows in the conductor is also directly proportional to the difference between its ends. Ohm’s Law is formulated as V = IR, where V is the voltage, I is the current and R is the resistance of the conductor. Ohm’s Law represents the most important mathematical relationship between voltage, resistance and current.

Current

According to Ohm’s Law, current flows on a wire conductor like water flows down a river. On the surface of a conductor, current flows from negative to positive. The electrical current contained in a circuit can be calculated by dividing the voltage by the resistance. The current is proportional to the voltage and is inversely proportional to the resistance. In this way, an increase in the voltage will result in an increase in the current. This can happen only if the resistance stays constant. If the resistance is increased and the voltage is not, the current will decrease.

Voltage

Voltage can be described as the difference in the electrical potential between the two points in the circuit. You can calculate voltage if the currant and the resistance in the circuit are known. If either the current or the resistance results in an increase in the circuit, the voltage will automatically increase.

Resistance

Resistance determines how much current will pass through a component. Resistors can be used to control current and voltage levels. A high resistance will allow only a small amount of current to pass through. Conversely, a very low resistance will allow a large amount of current to pass through. Resistance is measured in ohms.

Power

According to Ohm’s Law, power is the amount of current times the level of voltage at a given point. Power is measured in wattage or watts.

Related Articles

How to Calculate Voltage Across a Resistor
How to Calculate the Henrys in a Coil
How to Find Resistance With Power & Voltage
How to Use a Resistor for 12 Volt to 5 Volt
How to Test a Blower Resistor
How to Test Electrical Conductivity
How to Convert 12 Volt to 6 Volt
How to Reduce 12 Volt to 6 Volt
How to Convert mW to mA
How to Make a Simple Circuit
How to Convert a 9V Battery to 3.3V DC
How to Calculate IRMS
How to Power a LED
How to Calculate DC Voltage
How to Reduce Voltage on 12 Volt System to 4 Volt
How to Calculate How Long a Battery Will Last
How to Increase Amperes
How to Calculate Load Current
How to Calculate Millivolts to Amps
How to Calculate Battery Voltage

Dont Go!

We Have More Great Sciencing Articles!