How To Braze Copper To Steel With Silver Solder

Both soldering and brazing heat metals so that a filler metal (solder or brazing rod) melts, forming a bond. Unlike welding, the metals being bonded do not melt. Temperature distinguishes soldering from brazing. Generally, solder melts at less than 840 degrees F, and brazing rods melt at more than 840 degrees F. Both can contain silver. The higher the silver content, the stronger the bond but the hotter the temperature needed to melt the filler metal. Technically, you can either braze or solder, though you cannot braze with solder or solder with brazing rods. But you can attach copper to steel with silver solder using a propane torch, and call it whatever you like.

Step 1

Clean the surfaces of the metals you want to solder with solvent, emery cloth and a wire brush to remove all oil, dirt and corrosion. Try to make the metals shine. Silver solder adheres best to clean, bare metal.

Step 2

Apply a coating of flux to the steel where you are going to solder on the copper. Tin the copper by heating it and applying a thin coat of solder to the area that you want to solder to the steel.

Step 3

Hold the parts together with wire or clamps. The pieces should not move while you solder or while the joint cools. Make sure the parts fit flush. Silver solder cannot fill gaps between the metals–it will just flow through. But if needed, you can use bits of tinned copper wire as filler. Just make sure everything fits flush.

Step 4

Start heating the joint slowly with your torch, moving it closer as the flux heats up. Hold the flame directly on the joint until the flux either turns glassy or into a brown goo, depending on the flux you use. Melt the solder onto the joint. Let the metal melt the solder. Do not try to melt the solder with the torch.

Step 5

Clean the joint with the solvent and emery cloth or the brush after it cools. You can cool the joint by dousing it with water.